Danct12 changed the topic of #msm8937-mainline to: Boot Linux on your MSM8917/37/40 and QM215 mobile! | GitHub: https://github.com/msm89x7-mainline | Logs: https://oftc.irclog.whitequark.org/msm8937-mainline
<dr_shui[m]> still not working
<dr_shui[m]> [ 17.121848] qcom-wcnss-pil a204000.remoteproc: start timed out
<dr_shui[m]> [ 17.159587] remoteproc remoteproc0: can't start rproc a204000.remoteproc: -110
<dr_shui[m]> [ 11.745597] remoteproc remoteproc0: a204000.remoteproc is available
<dr_shui[m]> [ 11.754074] remoteproc remoteproc0: Booting fw image wcnss.mdt, size 7324
<dr_shui[m]> [ 11.753973] remoteproc remoteproc0: powering up a204000.remoteproc
<dr_shui[m]> what is remoteproc: start timed out?
<dr_shui[m]> vddpx-supply have added and  supply vddpx not found, using dummy regulator not shown
<Danct12[m]> <dr_shui[m]> "what is remoteproc: start..." <- basically main cpu (we call this apps cpu) tries to communicate with another cpu in the die (wcnss cpu) and got no response
<dr_shui[m]> <Danct12[m]> "basically main cpu (we call this..." <- what causes that ? wrong vdd-supply settings?
<barni2000[m]> supplies are fine
<dr_shui[m]> <barni2000[m]> "supplies are fine" <- That’s hard, what’s the next possible issue I haven’t solved
asriel has quit [Quit: Don't drink the water. They put something in it to make you forget.]
Danct12 has quit [Quit: ZNC 1.8.2 - https://znc.in]
Danct12 has joined #msm8937-mainline
asriel has joined #msm8937-mainline
<hacker420[m]> lanik123: https://bpa.st/5SAQ
<hacker420[m]> uart log from cedric
<hacker420[m]> with the fw built in
<hacker420[m]> and firmware-qcom installed
<hacker420[m]> kek
<hacker420[m]> pinctrl driver was disabled
<hacker420[m]> https://bpa.st/WA4A
<hacker420[m]> now enabled
<hacker420[m]> yeah now the backlight shuts off
<hacker420[m]> but I assume it should show the kernel log
<hacker420[m]> so it's either still missing something or
<hacker420[m]> lanik123: do I need these vsn and vsp regulators?
f_ has quit [Remote host closed the connection]
f_ has joined #msm8937-mainline
<hacker420[m]> this is how downstream looks
<hacker420[m]> hm
<hacker420[m]> so I am trying to figure out how to use pmi8950_wled
<hacker420[m]> but where do i get the parameters for it from
<hacker420[m]> ok found them
<hacker420[m]> so I added the regulators and wled backlight but still no output on screen
<hacker420[m]> at least backlight works now