06:02 <wens> problem with gerrit is that it has no concept of a pull request, only patches that just so happen to be in the same chain, so the only choice is to fetch the top commit as a branch

09:57 <jernej> karlp: I'm using browser to download patches from GH :)

09:57 <jernej> apritzel: I'll test it next week

09:59 <jernej> apritzel: I see only one patch, or do I have wrong link?

10:01 <jernej> apritzel: I noticed another potential issue. It's very possible that OrangePi 3 LTS board will have lower RSB speed, since due to trace routing, it doesn't allow for 3 MHz.

10:01 <jernej> which means RSB speed should be read from DT in such case

10:13 <MoeIcenowy> jernej: my RP-H6C does have good routing for RSB too

10:14 <MoeIcenowy> As this port is officially an I2C instead of RSB, maybe we shouldn't run any frequency higher than 400kHz

12:56 <apritzel> Hi, if anyone is at FOSDEM and wants to meet, I will be near the Pine64 booth in the AW building after 15.30

16:59 <blathijs> Anyone know of docs for the BROM behavior on H3? I'm assuming it's similar to A64, reading a key from serial, then checking the UBOOT pin to decide to either do FEL or boot from various storages (probably SD controllers in order with NAND inserted somewhere in the order?). Or are there peculiarities in there?

18:06 <smaeul> the H3 BROM behavior is almost exactly the same as A64. neither one touches the UART, so there is no "reading a key from serial"

21:56 <DarkNeutrino> jernej: you have few h616 devices. Could you output the opp table for them and upload them somewhere ? I have found sbc-bench quite useful for this for testing stability and also getting the output from it.