ChanServ changed the topic of #msm8937-mainline to: Boot Linux on your MSM8917/37/40 and QM215 mobile! | GitHub: https://github.com/msm89x7-mainline | Logs: https://oftc.irclog.whitequark.org/msm8937-mainline | Bridged to #msm8937-mainline:kde.org on Matrix
<Danct12[m]> barni2000: removed, thanks
<Danct12[m]> znc doesn't log connection logs so i dont know which host
<barni2000[m]> <M0xCAFEBABE[m]> "latest twrp with downstream..." <- i have tried with 3.4.0
<barni2000[m]> until camera stack is not initializing i will not see anything in twrp
<barni2000[m]> nvm my biggest issue is find out s5k3l8 i2c address, adding fixed-clock with camera pinctrl (that is very important) and set regulator-always-on-s helps me show the front camera address but i don't see the rear camera yet
<barni2000[m]> + set regulators on
<barni2000[m]> but unfortunately it is not enough for samsung sensors
<barni2000[m]> s/+/\+/
<NekoCWD[m]> barni2000 0x20 i guess
<barni2000[m]> i have tried 0x21 so it could make sens
<barni2000[m]> s/sens/sense/
<NekoCWD[m]> NekoCWD[m]: That's from bsp
<barni2000[m]> i2cdetect showed me 0x21 but it was not work thx i will try 0x20
<barni2000[m]> [ 13.981532] s5k2xx 2-0020: failed to find sensor: -6 :(
<barni2000[m]> maybe regulators are not correct
<barni2000[m]> Maybe stand by gpio is important because they are using the same i2c bus
ungeskriptet has quit [Remote host closed the connection]
ungeskriptet has joined #msm8937-mainline
<barni2000[m]> it should be 0x10 or 0x2d these are used by the sensor
<barni2000[m]> i cannot bring up s5k3l8 on land :(
<barni2000[m]> 1 register difference
<barni2000[m]> this seems to me the version register
<barni2000[m]> so technically they are same
<barni2000[m]> oh it seems 8940 can handle 3 camera
<barni2000[m]> s/camera/cameras/
<barni2000[m]> or not
<barni2000[m]> I have made a test branch 8937 camss, NekoCWD if you want to try with prada
<barni2000[m]> * test branch for 8937 camss,